Report Design
 Crystal Reports Forum : Crystal Reports 9 through 2020 : Report Design
Message Icon Topic: Command Line Question Post Reply Post New Topic
Author Message
youngbar
Newbie
Newbie


Joined: 01 Jan 2008
Online Status: Offline
Posts: 2
Quote youngbar Replybullet Topic: Command Line Question
    Posted: 01 Jan 2008 at 5:40am
I know this topic is for CR version 9.0 and above but....
 
 
Is there anyway to do command line batch printing of reports in version 8.5 WITHOUT Third Party utilities (including passing parameters)?
 
If not, can I convert a 8.5 version of a report to .NET 2005 and then do command line batch processing of reports?
 
Thanks!


Edited by youngbar - 01 Jan 2008 at 5:41am
IP IP Logged
BrianBischof
Admin Group
Admin Group
Avatar

Joined: 09 Nov 2006
Online Status: Offline
Posts: 2458
Quote BrianBischof Replybullet Posted: 01 Jan 2008 at 11:07am
I don't know how to do it with just CR and the command line, but you can use .NET 2005 and open the reports and print them out in batch mode without any problems. I personally haven't tried to open an 8.5 report using .NET, but I would hazard a guess that if it doesn't do it natively, then open the report within the .NET IDE and it should convert it automatically.
Please support the forum! Tell others by linking to it on your blog or website:<a href="http://www.crystalreportsbook.com/forum/">Crystal Reports Forum</a>
IP IP Logged
youngbar
Newbie
Newbie


Joined: 01 Jan 2008
Online Status: Offline
Posts: 2
Quote youngbar Replybullet Posted: 01 Jan 2008 at 12:00pm

Any one have any links that gives some examples of how to do this?  I may post on ASP.Net as well.

 

Thanks!

IP IP Logged
Post Reply Post New Topic
Printable version Printable version

Forum Jump
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum



This page was generated in 0.031 seconds.