Report Design
 Crystal Reports Forum : Crystal Reports 9 through 2020 : Report Design
Message Icon Topic: Select Expert help please Post Reply Post New Topic
<< Prev Page  of 4
Author Message
DBlank
Moderator
Moderator


Joined: 19 Dec 2008
Online Status: Offline
Posts: 9053
Quote DBlank Replybullet Posted: 31 Dec 2008 at 2:48pm

Not even close but thanks.

I also think you are on the right track with your other process. I assume you summed these at the client group level.
Note that my views above do not take that into account. They will exclude clients only base on codes and clients and are not look at the department at all. your process above is doing this if you summed at group 2. Not sure if you have clients that crossover departments. If so you need to decide how you want to address it. You can always adjust the views to include them, group and join as necessary depending on how you need to handle it.
IP IP Logged
Takesen
Senior Member
Senior Member


Joined: 29 Dec 2008
Location: United States
Online Status: Offline
Posts: 143
Quote Takesen Replybullet Posted: 31 Dec 2008 at 3:11pm
Yes, they are grouped in grp2. it seems to look fine. just need to verify.
and i honestly hate it still showing the large amount of records when there's only about 1500ish being displayed. i was thinking it would bring the numbers back down since i was using the select expert again. But perhaps it's because it's still a selection after the report's created? much like as if i were to use a suppress formula?
IP IP Logged
<< Prev Page  of 4
Post Reply Post New Topic
Printable version Printable version

Forum Jump
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum



This page was generated in 0.031 seconds.