Writing Code
 Crystal Reports Forum : Crystal Reports for Visual Studio 2005-2015 : Writing Code
Message Icon Topic: Adjust row height for the dynamic columns data Post Reply Post New Topic
Author Message
nayeem4umd
Newbie
Newbie


Joined: 01 Feb 2010
Location: India
Online Status: Offline
Posts: 13
Quote nayeem4umd Replybullet Topic: Adjust row height for the dynamic columns data
    Posted: 22 Feb 2010 at 7:59pm
Hi there,

Am been strut in one way, have developed a CR with dynamic columns and have written formulas for each columns that if the data exists then the border should display, everything is working fine the matter is when data spans for two to more lines then the data is displayed properly but the border and table alignment will get scattered, which removes the uniformity, how to come up with this issue, i wanna adjust the row height equally among dynamic data correspondingly to each field hope you got the point. the data displayed below will give you the clear picture...



Some Spanned
data
Some Data 2
Some Date 3





i want the data "Some Data 2" and "Some Data 3" to be also with the same height as "Spanned Data", how do i dynamically adjust the row height and width....

Regards
Nayeem



Edited by nayeem4umd - 22 Feb 2010 at 8:07pm
IP IP Logged
Post Reply Post New Topic
Printable version Printable version

Forum Jump
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum



This page was generated in 0.031 seconds.