Print Page | Close Window

Same Parameter prompted twice

Printed From: Crystal Reports Book
Category: Crystal Reports 9 through 2020
Forum Name: Technical Questions
Forum Discription: Formulas, charting data, Crystal syntax, etc.
URL: http://www.crystalreportsbook.com/forum/forum_posts.asp?TID=21415
Printed Date: 05 May 2024 at 7:06am


Topic: Same Parameter prompted twice
Posted By: Ianw
Subject: Same Parameter prompted twice
Date Posted: 07 Apr 2015 at 4:07am
Hi All,
 
I have an issue with my parameter. I have a command which is the base data of the report and a parameter set up so that when you run the report it will pass the parameter to the command and pull back the correct data.
 
However, when I refresh the report it will ask for the parameter twice. I do not have the parameter inserted into the report as opposed to the command and there is no sub report.
 
Has anyone come across this before and has a solution.  
 
I am running SAP Crystal Reports Developer. Version 14.0.2.364 RTM.
 
Thanks


Replies:
Posted By: kevlray
Date Posted: 07 Apr 2015 at 5:39am
Check the list of parameters,  make sure it is not listed twice for some reason.  Only thing I can think of.

Posted By: Ianw
Date Posted: 08 Apr 2015 at 4:19am
Thanks for your reply Kevlray. I have done a bit more research and it looks like when I only have the command parameter it only shows once. However, when I had a new report parameter then the command parameter is asked for again.
Do you know of any way were I can hide the command parameter?
 
Thanks

Posted By: kevlray
Date Posted: 08 Apr 2015 at 4:44am
From what I understand, you cannot hide a command prompt.  If it is not needed, you should be able to delete it.


Print Page | Close Window