Data Connectivity
 Crystal Reports Forum : Crystal Reports 9 through 2020 : Data Connectivity
Message Icon Topic: Default Values in Parameter Post Reply Post New Topic
Author Message
thummel1
Senior Member
Senior Member
Avatar

Joined: 27 Apr 2012
Location: United States
Online Status: Offline
Posts: 140
Quote thummel1 Replybullet Topic: Default Values in Parameter
    Posted: 11 Apr 2017 at 6:29am
Hi, I am using CR 2011. I am adding a command as my data source that contains 2 date parameters (Begin_Date) and (End_Date). In the Parameter Command, there is an option to have a default value for a date. I do not need this so I delete the date value and click OK. When I refresh the Crystal Report there is still a default value drop down box that appears for both Begin and End Dates.

How do I remove the default date value from the parameter? Thanks
"Press any key to continue. Where's the 'Any' Key?" ~Homer Simpson
IP IP Logged
hilfy
Admin Group
Admin Group
Avatar

Joined: 20 Nov 2006
Online Status: Offline
Posts: 3701
Quote hilfy Replybullet Posted: 25 Jul 2017 at 3:25am
You'll need to go to the parameter definition in the report (not in the Command editor) and remove the values there.

-Dell
IP IP Logged
Post Reply Post New Topic
Printable version Printable version

Forum Jump
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum



This page was generated in 0.031 seconds.