| Author |
Message |
frcikuk
Newbie
Joined: 18 Aug 2011
Online Status: Offline
Posts: 3
|
   Topic: duplex printing with CR11
Posted: 18 Aug 2011 at 3:16am |
|
Hi, I have a problem with duplex printing. Our printer supports duplex printing. When I print a document from Windows7, the printer prints on both sides of the page - that is correct, but when printing from our information system (information system used CR11 to display reports), the printer prints the document on a separate page - so it is not duplex.
How can I solve this problem? something has to be set in the report design?
Thanks
|
 IP Logged |
|
|
lockwelle
Moderator
Joined: 21 Dec 2007
Online Status: Offline
Posts: 4372
|
Posted: 18 Aug 2011 at 3:24am |
|
to the best of my knowledge, duplex printing is a function of the driver or printer. The application says here is the data, and here is how it should be printed. If it is working in the Windows7, then the application is sending the comands...it's up to the printer to get it right after that.
|
|
IP Logged |
|
frcikuk
Newbie
Joined: 18 Aug 2011
Online Status: Offline
Posts: 3
|
Posted: 21 Aug 2011 at 9:33pm |
|
if I open print preview in information system through crystalruntime and then print the report, the duplex is working properly (print on both sides of the sheet), but if I print directly (without print preview), the duplex does not work. Print two pages on two sheets ...
|
|
IP Logged |
|
lockwelle
Moderator
Joined: 21 Dec 2007
Online Status: Offline
Posts: 4372
|
Posted: 22 Aug 2011 at 2:39am |
|
I don't know about your setup, but everytime I view a report, it resets my printer settings, so I would always need to go to and set the duplexing option.
|
|
IP Logged |
|
frcikuk
Newbie
Joined: 18 Aug 2011
Online Status: Offline
Posts: 3
|
Posted: 22 Aug 2011 at 11:14pm |
|
ok, problem solved
thanks to all
|
|
IP Logged |
|
|
|
