Thanks

 

Matt

 

1.  Go to Page Setup on the File menu.

2.  Turn on "Dissociate formatting page size and printer paper size".  Also turn on "No Printer (optimize for screen display)"

3.  Set the width of the report to twice the paper size. If you want it to be on 2 8 1/2 x 11 portrait pages, set the paper size to 17 x 11 (ledger).

4.  Put fields A, B, and C to the left of the 10" mark (assuming you have .5 inch left and right margins) and fields D, E, and F to the right of the 11" mark (to start - you can tweak their location after validating that this works.)

 

Run your report.  When you print, set the print options to print on 8 1/2 x 11 paper, no scaling.  Make sure that "Fit horizontal pages to one page" is turned off.

 

-Dell

Hope this could helpful for you

 

Step1: Create two details section details (a) could contain Col A,B, & C and details (b) could contain Col D,E, & F.

Step2: Goto Details Section's Section Expert check format with multiple columns->select Layout tab->Change width size as for ex:21(indicates inch).

Step3: Select Details(a) sectionexpert check underlay follow section.

Step4: rigth click column A ->size and position->X-2(formula)->for ex:1100(indicates pixels)

so that u can able to split your columns into two pages