Writing Code
 Crystal Reports Forum : Crystal Reports .NET 2003 : Writing Code
Message Icon Topic: CrystalReportsViewer Cropping Report Post Reply Post New Topic
Author Message
rjoiner
Newbie
Newbie


Joined: 12 Feb 2009
Online Status: Offline
Posts: 2
Quote rjoiner Replybullet Topic: CrystalReportsViewer Cropping Report
    Posted: 12 Feb 2009 at 11:02pm
I'm using the CrystalReportViewer in VS .Net 2003, although I have a full version of CR 10, and I think it is picking up this viewer control.
 
The viewer has BestFitPage set to true
 
The navigator bar displays the full width but only the top left of any report is shown, and I have tried several.
 
I tried changing the width and height properties, and they make
the viewer container bigger but the report remain cropped off,
it is showing about 1/4 of the page.
 
Any ideas ?
 
Thanks


Edited by rjoiner - 12 Feb 2009 at 11:03pm
IP IP Logged
jkwrpc
Senior Member
Senior Member


Joined: 19 Jun 2007
Location: United States
Online Status: Offline
Posts: 432
Quote jkwrpc Replybullet Posted: 11 Mar 2009 at 1:27pm
I am not sure I fully understand the problem. The report itself is being cropped, check the printer page size.  I experienced what sounds like a similar problem with a ledger size report being cropped to a letter size. In my case, the resolution was in changing the printer to one that handled the correct paper size.
 
If it is the viewer itself just reducing to a smaller size, but the report is fully there (you just need to scroll to see it all) check how you have the viewer component docked to the form. Make sure the dock property is properly set.
 
Hope this helps.
 
Regards,
 
John W.
IP IP Logged
Post Reply Post New Topic
Printable version Printable version

Forum Jump
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum



This page was generated in 0.031 seconds.