Crystal Reports ?? Using Paramter Description in If Statement

Report Design
Crystal Reports Forum : Crystal Reports 9 through 2020 : Report Design

Topic: ?? Using Paramter Description in If Statement

Author	Message
jbalbo Senior Member Joined: 17 Feb 2011 Online Status: Offline Posts: 219	Topic: ?? Using Paramter Description in If Statement Posted: 02 Oct 2013 at 6:49am
	Hi I need to use the Description of a Paramter in an If statement Does anyone know if possible? Thanks
	IP Logged

DBlank Moderator Joined: 19 Dec 2008 Online Status: Offline Posts: 9053	Posted: 02 Oct 2013 at 7:42am
	not sure but why? if it is to display the description then you can use another if inside the formula to recreate the description based on the value otherwise youc an use the value
	IP Logged

Post Reply

Post New Topic

Printable version

Printable version

Forum Jump

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

This page was generated in 0.029 seconds.