Crystal Reports Blacked out report?

Report Design
Crystal Reports Forum : Crystal Reports 9 through 2022 : Report Design

Topic: Blacked out report?

Author	Message
myschif Newbie Joined: 15 Apr 2008 Online Status: Offline Posts: 7	Topic: Blacked out report? Posted: 23 Apr 2008 at 8:57am
	Hello, I have a crystal report running off a stored proc. It appears to run without any errors. When I page through it, certain sections are all black as if someone covered the section withblack paper. Other sections are fine? Any insight would be appreciated.
	IP Logged

myschif Newbie Joined: 15 Apr 2008 Online Status: Offline Posts: 7	Posted: 23 Apr 2008 at 10:06am
	Additionally, I noticed that the first customer group is fine. The next customer group which is on the same page as the first group begins as blacked out but is fine on the following page. Each customer group usually begins midway down the page, this part s always blacked out. The customer group continued on the next page is always fine? Has anyone experienced this?
	IP Logged

fusion Groupie Joined: 12 Nov 2007 Location: United States Online Status: Offline Posts: 93	Posted: 23 Apr 2008 at 6:51pm
	go to design view. Right click on the left side and choose the section expert Check there and see if there is any conditional formating appled to any section. That would be the first thing I woul do. If your customer group is starting midway down the page, select the Keep group together option on the section expert. Hope that gives you a starting point.
	IP Logged

Post Reply

Post New Topic

Printable version

Printable version

Forum Jump

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

This page was generated in 0.027 seconds.