I have a report with 6 subreports over 5 pages. The report saves the data on save.

The problem is when I save the report i get the following message. Unable to save data, press Yes to generate saved data.If I say Yes the data is generated and saved ok.

 

If I go to the last page of the report and then save the report I don't get the message as I have already generated the data by going to the last page.

 This is all okay if I run the reports manually. But Iam using CRViwer to generate reports by batch file. Is there any way I can remove the message or a way CRViewer can select the default in the message and continue to generate the report and save or is there a code I could put in the batch file to select the default message.

 

Cheers